Zenith PVR5269 Installationsanleitung PDF herunterladen (Seite 34)

REMOTE CONTROL Z-TRAK

PROGRAMMING YOUR Z-TRAK REMOTE

Your Z-Trak remote is already programmed to work with most

Zenith VCR's. If you have a non-Zenith VCR, or if your Zenith

VCR does not respond to your Z-Trak remote, you will need to

program your remote as follows:

1. Refer to the table of VCR Codes, in this section of

the guide. Locate the 3-digit number which corre-

sponds to your brand of VCR.

2. Make sure your TV is turned on.

3. While pointing the Z-Trak remote towards your

Zenith TV, simultaneously hold the MUTE and

ENTER keys until the TV displays a VCR "Setup"

screen (about three seconds). The VCR key will also

light upon entering the Programming mode.

4. Notice that the current VCR brand code (initially

"201") is displayed on the TV screen. Roll the track-

ball up or down (or use CHAN Up/Down) to choose

the 3-digit number of your VCR.

5. When the correct 3-digit number is displayed on the

TV screen, use the POWER key to make sure that

your VCR turns on and off properly. If it does not

respond, refer to the VCR Codes table to select a

different 3-digit number.

6. If your VCR turns on and off successfully, press the

trackball (or ENTER) to save the current VCR brand

code. The setup screen will disappear from the TV.

Also, the VCR key will flash 3 times upon exiting

the Programming mode. The remote will be in the

VCR mode.

7. Now try other controls on your VCR, such as Play,

Rewind, etc., to make sure that the correct VCR

brand code number was selected. (If not, repeat

steps 3 to 7.)

8. The MUTE key can be pressed at any time to cancel

Programming mode. The original VCR brand code

will remain unchanged.

NOTE: Only the VCR mode can be programmed.

9. The Z-Trak remote will exit Programming mode

automatically after 60 seconds if no key press or

trackball movement is detected.

AUTO FIND OPTION

If you have tried all 3-digit codes listed for your VCR manufac-

turer, and none of them operate your VCR, you will need to try

"AutoFind" to see if a different code will operate your VCR:

1. Make sure your VCR is turned on.

2. Simultaneously hold the MUTE and ENTER keys un-

til the VCR key lights up (about three seconds).

TV displays

VCR code

Equipment to be

controlled

Z-Trak Remote

Control

2923-o,-0 11 -- 3

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 97 98

Kommentare zu diesen Handbüchern

Keine Kommentare

Zenith PVR5269 Installationsanleitung Seite 34

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für LCD-Fernseher Zenith PVR5269