Zenith R60V26 Bedienerhandbuch PDF herunterladen (Seite 51)

PAGE 51

206-3594

Troubleshooting (Continued)

Symptoms Cause(s) Possible Solution(s) Page(s)

Sound/Audio Problems

Normal picture but no • Check volume levels. -Make sure the TV sound is not muted. 17

sound. • Try another channel. -The problem may be the broadcast, not your TV. 17/21

• A/V cables incorrectly connected. -Install the Audio cables correctly. 6 - 14

• Audio Out cables installed wrong. -Install external amplifier cables correctly. 14

• Internal Speakers turned off. -Turn internal speakers on in the Audio menu. 39

• No SAP signal. -If the Audio Mode is set to SAP, the channel may not

have an SAP program.

HD/DVD Problems

Picture looks wrong. • Wrong picture format. -Use correct aspect ratio for source’s image: 17/29

Normal, Wide, Zoom, etc. Press ASPECT repeatedly.

No picture or sound. • Wrong source selected on TV. -Select correct source equipment. 17

• Source equipment turned off. -Turn source equipment on.

• Tape or Disk not playing. -Press “PLAY” on source equipment.

• Try another channel. -The problem may be with the broadcast, not your TV. 17/21

• Wires incorrectly connected. -Install wires correctly on TV and equipment. 6 - 14

Menu Operation Problems

TV does not change menu • Select not pushed. -Be sure to press “Select” thumbstick center bulls-eye 17/19

option. when required as shown on menus.

• Remote in wrong mode. -Press TV to put remote into TV operating mode. 17

• Software lock-up. -Disconnect TV power cord from power outlet for 5 minutes.

• Parental Control on. -Turn Parental Control blocks off.

POP-3 / Split Screen Problems

TV screen shows 3 channels • POP-3 feature is on. -Press MULTI on remote to turn feature off. 17

on right side of screen.

TV screen shows 2 pictures. • PIP Screen feature is on. -Press PIP on remote to turn feature off. 17

Channel Tuning Problems

Can’t tune channels. • ANT 1 source not selected. -Press SOURCE on remote to show ANT 1 channels. 17

Can’t tune to a particular • Channel was deleted. -Reinstall channel to channel scan on Add/Del menu. 25

channel using CH Up/Down.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56

Keine Kommentare

Zenith R60V26 Bedienerhandbuch Seite 51