Zenith S2898A Betriebsanleitung PDF herunterladen (Seite 10)

2.1 INPUT CONNECTIONS

Connect source components and recorder according to the diagrams in the following pages. If using a

turntable, connect it to PHONO input only. If the turntable is equipped with a ground wire, connect it to the

ground terminal next to the PHONO input by unscrewing the terminal then inserting wire and tightening the

screw terminal onto the wire.

Do not

use ‘RCA-compatible’ connectors that have a hollow center pin with a hole at the tip – inserting

them into the Integrated 225’s RCA jacks can cause internal damage.

2.2 SPEAKER CONNECTIONS

Depending on the level of the input signal and volume setting, the voltage at the outputs can be high enough

to cause electric shock – be sure that power is turned off when connecting or disconnecting anything.

Ensure that the speakers are rated for use with this amplifier – an overdriven speaker can pose a fire hazard.

Connect the red (+) connection on the speaker to the red (+) binding post on the appropriate amplifier

channel, and the black (–) connection on the speaker to the black (–) binding post on the same amplifier

channel, using cable that is insulated to handle the maximum output of the amplifier. Do not overtighten the

binding posts as this may cause damage. Each binding post accepts a connection from one speaker.

2.3 TRIGGER

This feature allows the amplifier to be turned on or off remotely via the trigger. The 3.5mm (.125”) mini-jack

INPUT receives a 12V signal from an upstream component or system controller. The same trigger signal can

be linked to other components through the OUTPUT.

2.4 I.R. (INFRA RED) RECEIVER

External IR receivers allow the Remote Control to be used from other locations in your home. Once an IR

receiver is wired to another room, connect it to I.R. RECEIVER IN. The signal can be linked to other

components through I.R. RECEIVER OUT.

2.5 POWER

After the system is connected use the supplied power cord to connect power. It is normal for a ‘click’ to be

heard from inside the chassis when connecting power.

2. CONNECTIONS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Keine Kommentare

Zenith S2898A Betriebsanleitung Seite 10